Molding machine

Molding machine characteristics
Roll forming machine|
(1) molding machine computer host computer chips imported PLC to match the LCD screen, alternate software fault self-diagnosis system and error correction features that make the operation more convenient, its control program in order to fool design without professional training to job operations .
(2) molding machine hydraulic drive, with the country's first stepless hydraulic FM technology to solve the molding machine on a variety of materials and type of fitness, increase the density of the material, and to shorten the molding cycle.
Edit this paragraph
Use of the molding machine

1, select the flat table, put the stability of the machine, pull the chassis foot machine panel to facilitate the observation.
2, the hand-held sensor head plug into the socket on the front panel and tighten. Note Positioning gap ·
3 outlet power cord, plug one end into the chassis panel, the other end into the power supply outlet, be sure to use the single-phase three-wire power supply.
4, open the case to the panel power switch (POWER SW.), According to the panel power switch (SWITCHING) "key until the" ready (WARM UP) "green light, the machine can work.
Roll forming machine |
5, press and hold the set button (SETTING the BUTTON) key, set the appropriate value, generally in the range of 0.5-2.0 seconds.
6, the sensor head on the container lid above, click the start button on the handle, then heating (CONDITIONING) "red light, that is heating the sensor head will not remove the heating (CONDITIONING)" red light off and then remove the sensor head, "Prepare (WARM UP) the green indicator light machine buzzer short sound" beep "prompt and then a container sealing operations.
7, check the quality of seal, according to the different materials, the diameter of the container as well as production efficiency, proper trimming "setting button (SETTING the BUTTON) key, making the sealing of the best quality.
Edit this paragraph
The working principle of the molding machine

Molding machine works with an injection with the syringe, it is with the thrust of the screw (or plunger), the plasticizing good molten state (ie, viscous flow state), the plastic injected into the mold cavity closed good. After curing stereotypes made the process of the products.
Injection molding is a cyclical process, with each cycle including: dosing - molten plastics - to put pressure injection - filling cooling - Kai-mode pickup. Remove the plastic
Roll forming machine parts and then re-closed mode, the next cycle.

Forums:

The points which you have discussed in your Blog is really very informative. Thanks for sharing this information. I am working on a project on molding machine and your blog helped me a lot.mold components